Oil-Hydraulic Bent Pump Axial Pistons BENT AXIS PISTON PUMP
Transcrição
Oil-Hydraulic Bent Pump Axial Pistons BENT AXIS PISTON PUMP
Oil-Hydraulic Bent Pump Ref. BI Axial Pistons BENT AXIS PISTON PUMP (BI) Always read these instructions before using the pump. 1- Verify the rotation sense of the pump, right or left hand. And change it if needed (use drawing “Change rotation sense”, to do it); 2- Unscrew the drain hole; 3- Full fill the case with oil; 4- Screw the drain hole; 5- Apply the inlet and outlet connections in the pump; 6- Connect the pump to the PTO; BI 0504- 0 7- Connect the outlet and the inlet pipes to the pump (always respect the pipes dimensions and oil specifications indicated in the technical catalogue). ABER - Embraiagens e Comandos Hidráulicos - A. B. LDA Rua Francisco de Almeida, Nº 30 – Vila Nova da Telha – 4470 MAIA - Portugal Telefone: +351.22.9438070 Fax: +351.22.9420823 e-mail: [email protected] http://www.aber.pt 1/ 1 Oil-Hydraulic Bent Pump Ref. BI Axial Pistons Change Rotation Sense Pump Rotation: A-Right Hand Drain Hole 1 - Unscrew the four screws in totality. Body Y Body X 2 – Without separating the bodies X and Y , rotate 180º. BI 0504- 0 B-Left Hand 3 - Screw again the four screws , Torque 50-70 Nm. ABER - Embraiagens e Comandos Hidráulicos - A. B. LDA Rua Francisco de Almeida, Nº 30 – Vila Nova da Telha – 4470 MAIA - Portugal Telefone: +351.22.9438070 Fax: +351.22.9420823 e-mail: [email protected] http://www.aber.pt 1/ 1
Documentos relacionados
OIl-HYDRAULIC BENT PUMP AXIAL PISTONS
How to order: Example: Pump 50L,operating pressure up to 350 bar ;peak pressure 400 bar, ref. BI M BI50M ABER is constantly engaged in improving its products and, therefore, reserves itself the r...
Leia maisOIL-HYDRAULIC BENT PUMP AXIAL PISTONS
In the application of any of these pumps; the use of these data does not exempt the reading of the instruction ‘’BI pumps recommendations before start-up’’
Leia maisbent motor axial pistons (en) recommendations before
For MBI motors range, ABER recommends the use of high quality mineral oils type ISO HM or DIN 51524-2 HLP, with viscosities from 20 to 40 cSt at working temperature. The working viscosity limits st...
Leia mais