CEWI-OIL-Varnish Gloss
Transcrição
CEWI-OIL-Varnish Gloss
CEWI-OIL-Varnish Gloss TECHNICAL DATA Description CEWI-OIL-Varnish is a classic, very high gloss, full bodied varnish based on polyurethane modified alkyd resin and wood-oil. Optimum flow and long-lasting gloss retention. Suitable for all types of wood above the waterline, inside and outside Use CEWI-OIL-Varnish gives a full gloss polyurethane finish It is easy to use and dies very rapidly making it ideal when fast over coating is necessary. A hard varnish, it is abrasion resistant and UV resistant and can be used over existing varnish. Application CEWI-OIL-Varnish: apply evenly with brush ore spay. If sprayed always back brush immediately after each section is coated to ensure an even application! To avoid lap marks, start at one edge and follow through to end of the boards. Packaging /Containers Art-Nr. 51167 Gloss Containers: 1, 25 , 200 and 1000 lt Warranty When applied to new wood according to the directions on this label, if this product is proved to be defective after purchase , Böhme AG will furnish any necessary additional product free of charge or will refund the purchase price at the company’s option. This warranty does not include labour or cost of labour for the application of these products. This warranty gives specific legal rights , and also may have rights that vary from country / state to country/state Dual-System Apply a minimum of 3 coats to achieve desired appearance and colour. 2-3 layers of CEWI-OIL-Varnish with intermediate grinding (220-240). Cleaning Clean brushes and equipment with solvent Important Do not apply in direct sunlight, to hot surfaces, or when air or surface temperature is below 50 F Do not apply over wet or damp surfaces or when rain is imminent. Storrage Do not store above 25C. Shelf life : A minimum of five (5) years in closed containers at room temperature Coverage Surface Approximately: 120-150g/m2 Spread rates will increase when applying additional coats. This rate will vary upon the porosity of the wood. Be sure surface is free of all contamination such as dirt, mildew and loose wood fibres. UV and water resistant Böhme AG, Lack- und Farbenfabrik, Stationsstrasse 37, CH-3097 Liebefeld-Bern Telefon ++41 (0)31 971 11 63, Telefax ++41 (0)31 971 78 22, www.boehme.ch, [email protected] TECHNISCHES MERKBLATT Art.-Nr.: 51.167 CEWI OIL-VARNISH GLOSS PU-modifizierter lufttrocknender Alkydharz Wichtig Vor Gebrauch immer gut aufrühren damit die Mattierungsmittel gut verteilt werden! Farbton Farblos Glanzgrad Seidenglanz Trocknung Staubtrocken: nach ca. 2-4 Stunden 20°C Schleifbar: nach 12-14 Stunden Bei nasskalter Witterung kann sich die Trocknung verzögern Flammpunkt >45°C; Das Produkt enthält brennbare Lösemittel Viskosität Streichviskosität Spez. Gewicht Ca. 0.950g-0.970/ml/20°C GefStoffV/ Xi, N R10 -37-51/53-65-66-67 ADR-Transportgefahrenklasse RID/ADR KI. 3 Ziffer 31C Entsorgungscode VVS 1610 – Bei der Entsorgung ist die Verordnung über den Verkehr mit Sonderabfällen zu beachten Haltbarkeit Ungeöffnet min. 12 Monate bei Raumtemperatur +22°C Gebinde 1 l / 25 l / 200 l Verarbeitung Das Produkt ist verarbeitungsfertig eingestellt Verbrauch 120-150 g/m2 auf neuem Holz Gerätereinigung Terpentinersatz Nitroverdünner oder Reiniger P-86 Umweltempfehlung Darf nicht in Grund- / Oberflächengewässer gelangen. Dämpfe nicht einatmen. Vorsichtsmassnahmen Beachten Sie die Warnaufschriften auf den Gebindeetiketten SUVA Die sicherheitstechnischen SUVA-Richtlinien sind einzuhalten. Wichtiger Hinweis Verarbeitungsbeispiel Bei sehr hohen Ansprüchen wird die Zugabe von SUNBLOCKER-Konz. empfohlen. Eine Vorimprägnierung mit SunCare 900 erhöht die Lichtschutzwirkung zusätzlich. 1x ATMOSPHÄRENLACK Zwischenschliff : Korn 120-180 1-2 x Ablackieren mit ATMOSPHÄRENLACK Produktion Böhme AG: Diese technische Informationen, die wir zur Unterstützung des Käufers aufgrund unserer Erfahrung nach bestem Wissen und derzeitigem Erkenntnisstand geben, sind unverbindlich. Sie entbinden den Käufer nicht davon, unsere Produkte auf ihre Eignung für den vorgesehenen Verwendungszweck in eigener Verantwortung selbst zu prüfen. Sollte sich durch technische Weiterentwicklung eine Neuauflage ergeben, so verliert dieses Merkblatt an Gültigkeit. 030920 EU-Sicherheitsdatenblatt: ATMOSPHÄRENLACK® vom 15.9.2003